Free tool

Window cleaning price calculator

Count the panes, add screens, tracks and ladder work, and put in your pace and rate. You get hours, a price at your margin and a price per pane.

Adrian GluchowskiOwner of Superior Stain Solutions, builder of ChalkLast reviewed

The windows

Count panes of glass, not windows. A window with a grid of small lites counts every lite.

Extras
Time per item

Typical starting points, adjust to your crew. Time a few jobs and put in your own numbers.

Your numbers

Price

-
Panes
-
Price per pane
-
Labor hours
-
Job cost
-
Profit
-
Margin
-

Repeat visit

-
Profit
-
Margin
-

Where the time goes

Glass
-
Screens
-
Tracks and sills
-
Ladder or pole
-
Setup and travel
-

Window cleaning is sold by the pane and earned by the minute. Two houses with the same number of windows can be a $150 job and a $400 job, depending on the glass, the screens, the tracks and the ladder. This calculator starts from time, the way your day actually runs, and ends at a price per pane you can say out loud on the phone.

How the calculator works

  1. Count panes of glass by type. Standard panes, large panes (picture windows, sliding door panels) and the small lites in divided windows each have their own minutes. A true divided window with 12 separate lites is 12 small panes, not one window. Grids between the glass or snap-in grids do not count: that glass is one piece.
  2. Pick the sides. Outside only, or inside and outside. Each pane's time is counted once per side.
  3. Add the extras. Screens (take off, brush, put back), tracks and sills, and a ladder or pole surcharge for upper-floor and hard-to-reach panes. The ladder minutes apply to each side.
  4. Hours. All the minutes add up and round to the nearest tenth of an hour. Travel, setup and cleanup go on top and the total rounds to a tenth. Those rounded hours are the hours that get priced.
  5. Price. Labor plus supplies is your direct cost. The price is that cost divided by one minus overhead and margin, so overhead and profit come out as a share of the price. If the work comes in under your minimum charge, the price is the minimum, and the calculator says so.
  6. Repeat visits. A repeat customer discount comes straight off the price. The calculator shows the profit and margin you keep after it, because the discount comes out of profit, not out of cost.

The formula

  • Glass minutes = (standard x minutes + large x minutes + small x minutes) x sides
  • Other minutes = screens x minutes + tracks x minutes + upper panes x extra minutes x sides
  • Hours = (glass + other minutes) / 60 rounded to a tenth, plus setup, rounded to a tenth
  • Price = (hours x labor cost + supplies) / (1 - overhead% - margin%), or your minimum if that is higher
  • Price per pane = price / total panes

Worked example

The calculator opens on a typical two-story house: 20 standard panes, 4 large panes and 12 small divided panes, cleaned inside and outside, with 20 screens, 10 windows with tracks and 10 panes that need a ladder. Labor costs $30 an hour, overhead is 15%, the margin is 25% and supplies are $6.

  • Glass: (20 x 3 + 4 x 5 + 12 x 1.5) = 98 minutes a side, 196 minutes for both sides.
  • Screens: 20 x 1.5 = 30 minutes. Tracks: 10 x 2 = 20 minutes. Ladder: 10 panes x 2 minutes x 2 sides = 40 minutes.
  • Work: 286 minutes is 4.8 hours. Add 0.8 for travel, setup and cleanup (0.75 rounds to 0.8) and the job is 5.6 hours.
  • Cost: 5.6 x $30 = $168 of labor plus $6 of supplies is $174.
  • Price: $174 / (1 - 0.15 - 0.25) = $290.00. Overhead is 15% of that ($43.50), so the job costs you $217.50 and leaves $72.50, exactly 25%. That is $8.06 a pane.

The same house, outside only, with no screens or tracks, comes to 2.8 hours and $150.00, or $4.17 a pane. Setup and travel cost the same either way, so the second side is cheaper to add than the first was to do.

The minimum. A customer with 6 standard panes, outside only, works out to 1.1 hours and $65.00. With a $120 minimum, the price is $120, and the margin is 52.5% because the minimum is doing its job.

What a repeat discount costs. On the $290 job above:

DiscountRepeat priceProfit you keepMargin
None$290.00$72.5025.0%
5%$275.50$60.1721.8%
10%$261.00$47.8518.3%
15%$246.50$35.5214.4%
20%$232.00$23.2010.0%

A 10% discount takes about 6.7 points of margin, and a 20% discount takes away more than half your profit. If you want to give a regular a lower price, make sure the visit really does take less time. Maintenance cleans with no build-up go faster, so lower the minutes per pane before you lower the price.

This calculator's starting numbers are typical defaults and differ from the worked example in How much to charge for window cleaning; put in your own.

Pricing tips

  • Price from time, say it per pane. Customers think in windows, you earn in minutes. Work it out in minutes, then quote the price per pane or a flat price for the house.
  • Count lites, not windows. A divided window with a grid takes time per lite, and it is the biggest source of underpricing.
  • Treat the first clean differently. A window that has not been cleaned in years has build-up, paint specks and hard water. Price the first visit at the real time, and offer a lower recurring price for visits that stay on schedule.
  • Charge for screens and tracks as their own lines. They are real time. On a quote they can be optional extras the customer ticks.
  • Set a minimum. The drive and setup cost the same for 6 panes as for 60. The minimum protects the small stops.
  • Ladder and pole work is a different job. Height slows you down and adds risk. The surcharge here is minutes per pane. If a house needs a lift or a second person, price that on top.
  • Group your stops. A week of jobs in one neighborhood saves drive time. That is the cheapest way to raise your margin without raising a price.

For ladder setup, the OSHA ladder standard is a good rule of thumb even where it does not strictly apply to your work. It says a leaning ladder should be set so its base is about one quarter of the ladder's working length out from the support. See the sources below.

Common mistakes

  • Pricing by the window. A 12-lite French window is not one window of work.
  • Using someone else's per-pane price. A price per pane is the answer to your cost and your pace. Another company's number hides their costs.
  • Forgetting that inside is slower. Moving furniture, protecting floors and working around blinds take time that the outside does not.
  • Giving the repeat discount first. Offer it after the first visit, once you know the real time.
  • Rounding hours up to be safe. Round your time honestly and fix the problem where it is, in your rate, your margin or your minimum.

FAQ

How much should I charge per window?

There is no universal number. Your price per pane depends on your labor cost, your pace, your overhead, the mix of glass and how much you want to keep. Put your own numbers into the calculator and it gives you a price per pane at your margin. Then compare that with what you are quoting today.

Should I charge by the pane or by the hour?

Work it out by time, then quote by the pane or as a flat price. Pane pricing is easier for the customer to understand and compare. Hourly pricing is fair when the job is hard to predict, such as a first clean after years of build-up.

How long does a window take to clean?

It depends on the glass, the build-up, the tools and the person. The defaults here (3 minutes for a standard pane per side, 5 for a large one, about 1.5 for a divided lite) are starting points, not published figures. Time three real jobs and use your own averages.

Do I charge extra for screens and tracks?

Most crews do, because they are real minutes. Put them in as their own lines so the customer can see what they are paying for and choose.

How should I price recurring window cleaning?

Price the first visit at full time, then set the repeat price from the shorter time a maintenance visit takes. Check what any discount does to your margin before you offer it. The table above shows the effect.

What minimum should I set?

Enough that a small stop still pays for the drive, the setup and a margin. Run a small job through the calculator, like 6 panes, and see what the minimum has to be to keep the margin you want.

Does the calculator include sales tax?

No. Whether window cleaning is taxable depends on your state and sometimes your city. Ask your state revenue department or your accountant.

Sources

  • Occupational Safety and Health Administration, 29 CFR 1926.1053, Ladders: the rule on setting a leaning ladder so its base is about one quarter of the working length from the support, and on extending a ladder at least 3 feet above an upper landing.
  • Minutes per pane, per screen and per track, the ladder surcharge, supplies and setup time: typical starting points, not published figures. Adjust them to your crew and the glass. The best numbers you will ever have are your own.