Pricing guide

How much to charge for window cleaning

Per pane, per window or hourly: how to price residential window cleaning, screens and tracks, upper floors and minimums, with a worked house quote.

Adrian GluchowskiOwner of Superior Stain Solutions, builder of ChalkLast reviewed 11 min read

On this page

Window cleaning is one of the few trades where a good week and a bad week have the same customers. What changes is how you counted. A house with 22 windows can be a two-hour exterior wash or a seven-hour inside-and-out job with screens, tracks, hard water and a second story. Customers see 22 windows. You have to see the work.

This guide shows how to price residential window cleaning three ways (per pane, per window, hourly), how to count and classify what you see, what to charge for screens, tracks and upper floors, how a recurring discount eats your profit, and how to set a minimum. It ends with a worked quote for a 22-window house.

What homeowners see online

Customers read cost guides, and the numbers are consistent enough that they will quote them to you.

WhatThis Old House (updated March 2026)FieldCamp
Per pane$4 to $8$4 to $8 (casement up to $15, mineral removal up to $12)
Per window$8 to $40, average $10 to $15$4 to $15; single or double hung $8 to $16, sliding $8 to $10, casement $15 to $30
Whole house$100 to $50015 windows about $250, 24 windows about $350
Screens, per window$5 to $10$0.50 to $8 per screen
Sills and tracks, per window$0.05 to $5, average $3$2 to $4
Second story, extra per window$3 to $5not listed
Hard water stain removal, extra$10 to $30 per window$10 to $30 per window
Minimumnot listed$75 to $150

Sources: This Old House (cost data from Fixr and HomeGuide) and FieldCamp, a software company. Both are national and both mix inside-and-out with exterior-only. They are a check on your price, not a way to set it.

Per pane vs per window vs hourly

ModelHow it worksGood forWatch out for
Per paneCount the pieces of glassHouses with varied windows, because it follows the workCustomers argue about what a pane is
Per windowA set price by window typeSimple quotes and price listsLarge or odd windows get underpriced
HourlyTime x rateHard jobs, post-construction cleaningIt punishes your speed

Most residential cleaners quote per window by type, check it against a per-pane figure, and apply a minimum. Hourly pricing works for jobs you cannot see: construction dust, paint on the glass, a house you have not entered.

Say what a pane is. On a double-hung window each sash is a pane, so a standard double-hung is two. A casement is usually one. A patio slider is two. Grids between the glass or snap-in grids do not multiply panes: the glass is one piece. True divided lites (separate small panes set in muntins) count one pane each, the way the window cleaning calculator counts them. Write your rule on the price list: "price per window includes all glass in the window."

Count and classify

Do a walk-around and count every window, with a note on the type and the floor.

Window typePanesWhat takes time
Double-hung2Tilt-in sashes are fast. Old ones that do not tilt are slow.
Single-hung or fixed (picture)1Big pieces. Fast, but need a big squeegee and sometimes a ladder.
Casement or awning1Hinges and cranks. Care with screens.
Slider2Tracks collect dirt.
Patio or French door2 to 12Fingerprints and dog nose prints. Count the panes.
Basement or well window1Dirt, webs, wells to climb into. Price as its own line.
Skylight, storm, sunburstvariesSpecialty. FieldCamp lists $25 to $40 for these.

Then write down five modifiers: screens (how many), tracks and sills (how dirty), hard water (white film or etching), floor level (ground, second story, third) and access (shrubs, a locked gate, a deck in the way).

Panes per hour

Like most trades, window cleaning has no standard published rate. Cleaners on trade forums give very different numbers.

In one thread on the WindowCleaner.com forum, a two-person crew reported 30 to 40 panes per home in 3 to 4 hours inside and out, which works out to about 7.5 to 13 panes per hour for the pair. Another poster described 100 panes in one inside-and-out job in 6 hours, about 17 panes per hour. A regular two-story exterior-only job at $35 to $45 took about half an hour. Others quoted jobs per day from 2 or 3 for a thorough in-and-out cleaner to 10 or more exteriors for a three-person crew. Those are individual claims, not tested numbers, and they mix very different work.

The lesson is that the same crew can be at 4 panes per person-hour or 17 depending on what they are doing. Time your own work in these buckets:

TaskWhat you record
Exterior glass only, ground floorpanes per person-hour
Interior glasspanes per person-hour
Screens: remove, brush, rinse, replaceminutes per screen
Tracks and sillsminutes per window
Second story, ladder or poleminutes added per window
Hard water or heavy soilminutes added per window
Setup, walkthrough, cleanupminutes per job

For the worked example below, the placeholder is 8 panes per person-hour inside and out, a pace that leaves room for moving furniture, dirty glass and talking to the customer. It sits inside the forum range. Replace it with your own.

Screens, tracks and hard water

These are the three things that eat a day if you do not charge for them.

  • Screens. Taking out, brushing and rinsing a screen costs a couple of minutes. This Old House lists $5 to $10 per window. Charge per screen, or fold it into a price per window and say so.
  • Tracks and sills. A dirty track is a detail job with a brush and a vacuum. List it as a line item per window.
  • Hard water. Mineral film and etched glass are not cleaning, they are restoration, and they take products and time. Price by the window and tell the customer that etching cannot always be removed. Do not promise a fix without a test patch.

Write these on the quote as separate lines or Optional extras. The base price is the glass. The rest is a choice, which customers like, and it protects your hours.

Upper floors and ladders

A window on the second floor is not the same job as a ground-floor window. Add a line to your pricing for it. This Old House puts the extra at $3 to $5 per window above ground level.

If you use ladders:

  • Set the ladder at the right angle. For straight and extension ladders, OSHA's rule is to set the base about one quarter of the ladder's working length (foot to top support) out from the wall, about 75 degrees. See 29 CFR 1926.1053 for the current text.
  • Three points of contact and no carrying buckets up a ladder. Use a bucket hook or a belt.
  • Firm, level ground. Not on wet grass, mulch or a slope. Use levelers.
  • Look up for power lines before you raise anything. Use a fiberglass (nonconductive) ladder near any wires. OSHA requires people who are not trained electrical workers to keep themselves and anything conductive they hold, ladders included, at least 10 feet from overhead lines up to 50 kV (29 CFR 1910.333(c)(3)), and requires nonconductive side rails where a ladder could touch live equipment (29 CFR 1926.1053(b)(12)). Treat the service wire to the house as live.
  • Know your limit. Third-story windows and windows over a roof are a ladder-jack, lift, pole or refer-it-out job.

Many companies use a water-fed pole from the ground for upper windows, which cuts ladder risk. It is a different method and a different price. If you quote one method, do not switch on the day.

Minimums and recurring discounts

Minimum. FieldCamp suggests $75 to $150 and shows how it gets there: $50 of fixed costs plus 25% is $62.50 (that is a 25% markup; a true 25% margin would be $66.67), rounded up to $75 to $100. Work out yours the same way. A solo operator with 0.5 hours of travel, 0.25 of setup, 0.5 of cleaning and 0.25 of cleanup is 1.5 hours, which at $25 an hour is $37.50. Add $8 for supplies and $10 for equipment for $55.50, and divide by 0.65 to get a minimum of about $85.

Recurring discounts. Many shops offer 10% off for a quarterly or monthly plan. That is not as small as it sounds. Use the example house below, where the price is $344 and the direct cost is $223.75:

DiscountPriceWhat is left after direct costChange in what you keep
None$344$120.48
5%$327$103.27down 14%
10%$310$86.06down 29%

A 10% discount takes 29% of the money that pays for overhead and profit. Offer it only if repeat visits really are faster, or if the route density saves you drive time. Many shops give something else instead: a guaranteed time slot, a free screen wash or a price lock for the year.

Repeat visits are often cheaper to do, because the glass is cleaner and the customer has fixed the problems you pointed out. Test it: time your second and third visits and see if the hours fall. If they do, pass some of the savings on.

Worked example: 22 windows

The job: a two-story house with 22 windows, inside and out, with screens and tracks. The windows are 12 double-hung (24 panes), 4 casement (4 panes), 2 picture windows (2 panes), 1 slider (2 panes), 1 patio door (2 panes) and 2 basement windows (2 panes), so 36 panes. Eight windows are on the second floor. No hard water.

Placeholders: labor costs $25 per hour (a $20 wage plus 25% burden). Overhead is 20% of price and profit is 15%. One person, 8 panes per hour inside and out.

TaskRateHours
Walkthrough and setupallowance0.50
Glass, inside and out36 panes at 8 per hour4.50
Screens, 222 minutes each0.73
Tracks and sills, 223 minutes each1.10
Second floor, 8 windows3 extra minutes each0.40
Drive and cleanupallowance1.00
Total8.23
ItemAmount
Labor, 8.23 h x $25$205.75
Supplies and equipment$18.00
Direct cost$223.75
Price = $223.75 / 0.65$344
Overhead share (20%)$69
Profit share (15%)$52

That is $15.65 per window and $9.56 per pane. This Old House lists $10 to $15 for an average window and $4 to $8 per pane, so this is a little above its range. FieldCamp's size table (24 windows about $350) lands almost exactly on it. The gap is the useful part: this example includes screens, tracks and eight upper windows, which a plain per-window average does not. If your market is cheaper, you are either faster than the placeholder or the customer is comparing a lighter job.

Round it into a price list the customer can read:

LineQtyUnitTotal
Window glass, inside and out (includes setup and drive)22$11.50$253
Screens22$1.50$33
Tracks and sills22$2.00$44
Second floor8$2.00$16
Total$346

Each line is that task's share of the hours, with setup and drive folded into the glass line. The $2 over $344 is rounding.

What to tell the customer: "I clean all the glass inside and out, wash the screens and wipe the sills and tracks. Mineral stains and etching on glass are not always removable. If you have them, I will tell you before I start."

Storefronts in brief

Storefront and small commercial glass is a different business. It is priced per visit on a route, and the money is in the route, not the glass. Time the stop (usually minutes), add the drive between stops and charge for both. Weekly or biweekly work, cash flow on a card on file and a clean invoice matter more than the price per pane. If a route is where you want to go, price it the way you would the lawn route in How to price leaf removal and fall cleanups: by the visit, with your drive time inside the price.

Mistakes to avoid

  • Quoting by square footage of the house. The window count and types decide the time.
  • Not defining a pane. Write the rule on the price list.
  • Giving away screens and tracks. Make them lines.
  • Flat price for hard water. It is restoration. Quote it by the window after a test patch.
  • Cleaning in direct hot sun or freezing weather. Glass streaks fast on a hot day and freezes on a cold one. Move the job.
  • Discounting the recurring plan without checking the hours. See the table above.
  • No minimum. A three-window job still costs a trip.
  • Ignoring the second floor. Ladders and poles are time.

How Chalk helps

This part is about our software.

  • Price book. Add your window lines to the price book with the unit each and a price per window by type, plus a line for screens, tracks and your minimum. Picking them onto a quote takes a tap. See Send a quote and get it approved.
  • Optional extras. Mark screens, tracks or hard water treatment as an Optional extra so the customer ticks what they want.
  • Regular customers. Book a repeating series from the job. Under Repeats, the choices include Every 3 months, Every 6 months and Every year. You can also have each visit's invoice drafted when the visit is marked done (Invoicing for each visit), left for you to check and send.
  • Rain day. Exterior glass is weather work. More > Rain day on the calendar moves every visit on a wet day in one go, and nothing goes to a customer unless you tick Let the customers know.

Want to check your hourly cost? Use the hourly rate calculator or read How to figure your hourly rate. To compare markup and margin, use the markup and margin calculator.

Sources

Prices and rates change and vary by region. Check the current version of each source.