Pricing guide

How much to charge for roof cleaning (soft wash)

Price roof soft washing by the square foot or roofing square: pitch, stories, chemical cost, plant protection, and a worked ranch-house example.

Adrian GluchowskiOwner of Superior Stain Solutions, builder of ChalkLast reviewed 11 min read

On this page

Roof cleaning is the highest-risk, highest-ticket service most washing companies offer. A house wash is $500 or $800. A roof wash on the same house can be $750 to $1,500, with chemicals that can kill a customer's shrubs, a surface that can hurt your crew, and a customer who thinks you are removing "dirt" when you are really killing algae that will come back.

This guide shows how to price a roof soft wash from the roof's real area (not the house's), why pitch matters, what the shingle makers' trade group says about methods, how to work out chemical cost, how to price plant protection and safety, and what to put in your warranty language. It ends with a worked example for a ranch house.

What homeowners see online

Published roof cleaning prices are scattered and low in quality. These are the ones that hold up:

SourceWhat it says
Fixr (updated January 2025)Washing a roof: $450 to $700 as a typical total
A soft-wash equipment supplier's roof guide (2026)$0.30 to $0.50 per sq ft of roof surface. A 2,000 sq ft house has roughly 2,400 to 2,800 sq ft of roof. A residential soft wash takes about 2 to 3 hours for an experienced crew
Pressure Washing Resource forumOne contractor: "around here that would be about $1100 for the house." Not a benchmark, a data point

The supplier sells soft-wash equipment, so read it as a market view and not as neutral advice. Notice the unit: the $0.30 to $0.50 is per square foot of roof, not of house. A customer who reads a per-square-foot price and multiplies it by their floor area will underestimate the quote.

Roof area vs house area

A roof is bigger than the floor under it, for two reasons: the overhang past the walls, and the pitch.

Roof area = (house footprint plus overhangs) x pitch factor Pitch factor = the square root of (1 + (rise / 12)^2), where rise is the inches of rise per 12 inches of run

Because the roof surface is the hypotenuse of a right triangle, the factor is plain geometry:

Pitch (rise in 12)Factor
3 in 121.031
4 in 121.054
5 in 121.083
6 in 121.118
7 in 121.158
8 in 121.202
9 in 121.250
10 in 121.302
12 in 121.414

To measure: get the outside length and width of the house, add the overhang on every side (a common overhang is 1 to 2 feet; measure it), multiply for the footprint, then multiply by the factor. Measure the pitch with a level and a tape, or a phone app, from the gable end or an attic rafter. For complex roofs, break the roof into planes and add them. Add an allowance for dormers, valleys and chimneys, or measure from aerial images and check on site.

Roofing squares. Roofers sell and price in squares, where 1 square is 100 sq ft. Some roof washers price this way too. The example below is 24.3 squares.

Walkable vs not

The first question is whether anyone can safely be on the roof.

  • Where to apply from. Soft washing is low pressure. Many roofs can be treated from the ground or a ladder with a long wand. Steeper roofs are done with fall protection, aerial lifts or other methods. The supplier guide above says pitches above 6 in 12 call for anchor points and rope systems or aerial equipment.
  • Fall protection law. OSHA says fall protection is required at six feet in the construction industry and at four feet in general industry. Which rule applies to roof cleaning depends on the work and your state. Ask your insurer and your attorney.
  • Surface. A wet or chemically treated roof is slippery. ARMA, the asphalt roofing manufacturers' trade group, says the cleaning process can make a roof slippery and recommends trained professionals.
  • Material. Asphalt shingles, metal, tile, slate and wood shake are different jobs. Know what you are doing before you quote a surface you have not cleaned.

If you cannot do it safely, decline it or sub it to someone who can. That is a business decision, not a failure.

What the shingle makers say

ARMA's guidance on algae discoloration is the reference most roof washers should know:

  • It says not to use a power washer, brush or broom on an asphalt roof. High-pressure washing is likely to damage asphalt roofing, and friction can loosen granules.
  • It suggests a mix of household bleach and water, and in an older technical bulletin a typical solution of one part chlorine bleach to one part water. Directions vary by shingle maker and by how heavy the staining is.
  • It says to leave the solution on for at least 15 minutes but no more than 20, then rinse gently.
  • It says other cleaning chemicals or methods should not be used without the shingle manufacturer's approval.
  • It says the cleaning effect is temporary and the staining may return.
  • It recommends algae-resistant shingles when a roof is replaced.

This matters for your price and your paperwork. Your customer's shingle warranty may have conditions about cleaning. ARMA says cleaning needs the maker's approval for anything other than its suggested solution, and that is for the customer to check. Say so on the quote.

Chemical cost per square

Soft washing roofs usually uses sodium hypochlorite (SH) mixed down from a strong concentrate, with a surfactant so it clings. The supplier guide gives these numbers:

  • Concentrate from a chemical supplier is 10% to 12.5%.
  • The working solution is 3% to 6%: about 3% for light algae, 4% to 5% for moderate staining or moss, and 5% to 6% for heavy lichen. Forum contractors in the thread above say 3% to 4% is enough on most roofs.
  • Surfactant is 2 to 4 oz per gallon of mixed solution.
  • A neutralizer for plants (sodium thiosulfate) is 1 to 2 oz per gallon.

Many sodium hypochlorite products are EPA-registered pesticides, and federal law makes it unlawful to use a registered pesticide in a way its label doesn't allow (FIFRA, 7 U.S.C. 136j(a)(2)(G)). Check the label for the surfaces and strengths it allows, and ask your state pesticide agency whether cleaning roofs or siding for pay needs an applicator license.

Working it out is a dilution problem:

Concentrate needed = mix gallons x target % / concentrate %

For 61 gallons of mix at 4% from a 12.5% concentrate: 61 x 0.04 / 0.125 = 19.5 gallons of concentrate and about 41.5 gallons of water. Stronger is not better. It is riskier for the roof, the plants and you.

How much mix does a roof take? That depends on your sprayer and how wet you apply, so measure it. Spray a measured 100 sq ft at your normal pass speed and see how many gallons go on. The worked example uses a placeholder of 1 gallon per 40 sq ft. Replace it with your number.

Plants, gutters and runoff

This is where roof washing jobs go wrong.

  • Wet the plants first with clean water, cover delicate ones, and rinse everything again at the end. Many crews also apply a neutralizer to the plants.
  • Downspouts. Decide where the runoff goes. Some crews bag the downspout bottoms or divert them to a landscaped area or a collection bucket. Roofs wash into gutters, and gutters wash onto the lawn, the driveway and the street.
  • Storm drains. Many cities restrict what may go down a storm drain, and the runoff from a roof can reach one. The existing pressure washing pricing guide covers the wash water warning and the EPA fact sheet. Check your local rules, and price the extra labor and materials.
  • Metal and paint. Chemicals can damage or stain metal and painted surfaces. Cover vents, flashings and anything you cannot rinse.
  • Neighbors, pets and cars. Move them, or warn them.

All of this is time. It belongs in the price as setup and rinse hours.

Production

No official production rates exist. The supplier guide says a residential soft wash takes about 2 to 3 hours for an experienced crew, which is application time and not setup, rinse or travel. Your hours depend on pitch, height, number of planes, access and how much plant protection the property needs.

Record these on your next ten roofs: drive, setup and plant protection, ladders and access, application (sq ft per crew-hour), dwell time (not billable if you are on another task), rinse of plants and downspouts, cleanup. Time dwell separately: ARMA's 15 to 20 minutes is the dwell for its suggested solution, and contractors on forums describe different habits. Follow the shingle maker.

Worked example: a ranch house

The job: a one-story ranch, 60 by 30 feet with a 2-foot overhang all round, a gable roof at 6 in 12, asphalt shingles with moderate algae streaks. Walkable from a ladder-fed system with an extension wand. A two-person crew.

Roof area:

StepResult
Footprint with overhang: (60 + 4) x (30 + 4)2,176 sq ft
Pitch factor at 6 in 121.118
Roof area2,433 sq ft, or 24.3 squares

Chemicals (placeholders): 1 gallon of mix per 40 sq ft is 61 gallons of mix, at 4% from 12.5% SH is 19.5 gallons of concentrate at $3.50 a gallon, which is $68. Surfactant at 3 oz per gallon is 183 oz, or 1.43 gallons at $25, which is $36. Chemicals total $104, or $4.27 per roofing square.

Placeholders: labor costs $32.50 per person-hour (a $25 wage plus 30% burden). Equipment is $15 per site hour. Overhead is 20% of price and profit is 15%.

TaskCrew-hours
Round-trip drive1.00
Setup, wet and cover plants, protect downspouts0.75
Apply to 2,433 sq ft, including dwell and a second pass on streaks2.50
Rinse plants, downspouts and walkways, cleanup0.75
Total5.00
ItemAmount
Labor, 5.0 crew-hours x 2 x $32.50$325.00
Equipment, 4.0 site hours x $15$60.00
Chemicals$104.00
Direct cost$489.00
Price = $489.00 / 0.65$752
Overhead share (20%)$150
Profit share (15%)$113

That is $0.31 per square foot of roof and $31 per roofing square. It sits at the low end of the supplier guide's $0.30 to $0.50 and inside Fixr's $450 to $700 and the forum's $1,100 for a house. If your market pays more, you can charge more, and keep the extra. If your market pays less, check your hours before you cut the price.

Adjusting for the real world:

ChangeEffect
Steeper roof (8 in 12)Area x 1.202 / 1.118, so about 7.5% more roof, plus fall protection setup
Two storiesMore ladder time, more risk, and often a fall protection requirement
Heavy moss or lichenA stronger mix, a second pass, more rinse
Lots of plants close to the houseMore hours for protection and rinse
Metal, tile or slate instead of asphaltA different method and product. Do not quote it from this table.

Warranty language

Be honest on paper. ARMA is clear that the cleaning effect is temporary and staining may return, so do not promise otherwise. A sample for your terms (have your attorney check it):

"We clean algae and moss from your roof with a low-pressure soft wash. Results vary and algae can grow back, especially on shaded or damp sides. We do not guarantee how long the roof will stay clean. We are not responsible for roofing that is already worn, loose or damaged. Check your shingle warranty for any conditions about cleaning. Plants near the house are protected as described, but some damage can happen despite care."

Offer a repeat visit at a fixed price, and a limited re-treatment if streaks reappear within a stated period you can afford. Do not offer a "lifetime" anything.

Photograph the roof before you start. Roofs with missing granules, lifted tabs or old leaks look worse after cleaning, and the customer will blame you.

Mistakes to avoid

  • Pricing by house square footage. Use roof area.
  • Pressure washing a shingle roof. ARMA says not to.
  • Using stronger chemicals than the shingle maker allows.
  • Walking a roof you cannot walk.
  • Skipping plant protection and rinse time.
  • Forgetting downspouts and storm drains.
  • Promising the roof will stay clean.
  • No insurance check. Ask your agent about roof work and chemical runoff.
  • Quoting without a pitch. The factor changes the area by up to 40%.

How Chalk helps

This part is about our software.

  • Price book by the foot. Add roof cleaning to the price book with the unit sq ft and a price per square foot of roof, and put the measured roof area on the quote, not the house's. Add plant protection or a steep-roof surcharge as separate lines. See Send a quote and get it approved.
  • Optional extras. Mark gutter cleaning or a house wash as an Optional extra so the customer ticks what they want.
  • Photos on the job. Upload Before and After photos to the job. They are the best record of the roof's condition.
  • Rain day. Roof washing needs a dry forecast. More > Rain day on the calendar moves a wet day's visits in one go, and nothing is sent unless you tick Let the customers know.
  • Come back in a few years. Set the job type's Due again after in Settings > Lists (for example 24 months), and finished roofs become a lead on the funnel when the algae is likely back. The repeat-work text to the customer is off until you turn it on in Settings > Automations.

Sources

Prices and rates change and vary by region. Check the current version of each source.